1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE INTERCOOLER ASSEMBLY
4.REMOVE NO. 1 ENGINE UNDER COVER
5.REMOVE NO. 2 ENGINE UNDER COVER
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
7.REMOVE FRONT FENDER APRON SEAL UPPER
Remove the 5 clips and front fender apron seal upper.
8.REMOVE FRONT FENDER SEAL
Remove the 5 clips and front fender seal.
9.REMOVE AIR CLEANER ASSEMBLY
Disconnect the mass air flow meter connector and detach the wire harness clamp.
Loosen the hose clamp of the compressor inlet elbow.
Remove the 2 bolts and air cleaner.
Loosen the hose clamp and remove the No. 1 air cleaner hose.
10.REMOVE VENTILATION PIPE
Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.
11.REMOVE COMPRESSOR INLET ELBOW
Loosen the clamp, and then remove the compressor inlet elbow and air cleaner hose from the turbocharger.
12.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 2 bolts and No. 1 exhaust manifold heat insulator.
13.REMOVE TURBINE OUTLET ELBOW
Remove the 4 nuts, turbine outlet elbow and gasket.
14.REMOVE TURBOCHARGER STAY
Remove the 2 bolts, nut and turbocharger stay.
15.REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY (w/ Intercooler)
Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.
16.REMOVE TURBOCHARGER SUB-ASSEMBLY (w/ Intercooler)
Remove the 3 nuts, turbocharger and gasket.
17.REMOVE EXHAUST MANIFOLD
Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold as shown in the illustration.