Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD(for DPF) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052346 INTAKE MANIFOLD(for DPF) A

2KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD(for DPF)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 4.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 5.DISCONNECT WIRING HARNESS CLAMP BRACKET

Hide 8.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 10.REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET

a.
A271957

Remove the bolt and No. 3 intercooler support bracket.


Hide 13.REMOVE NO. 1 INTAKE MANIFOLD INSULATOR

Hide 14.REMOVE INTAKE MANIFOLD INSULATOR

a.
A245459

Remove the intake manifold insulator.


Hide 15.REMOVE INTAKE MANIFOLD

a.

Remove the bolt and disconnect the fuel hose protector from the intake manifold.


b.
A245461

Detach the sensor wire connector clamp from the intake manifold.


c.
A271832

Remove the 4 bolts, 2 nuts, intake manifold and gasket.