1.REMOVE TAILPIPE ASSEMBLY
Remove the 2 bolts and 2 nuts.
Disconnect the tailpipe from the center exhaust pipe and remove the gasket.
Remove the tailpipe from the exhaust pipe support.
2.REMOVE CENTER EXHAUST PIPE ASSEMBLY
Remove the 2 bolts and 2 compression springs.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the gasket.
3.REMOVE NO. 2 ENGINE UNDER COVER
4.SUPPORT TRANSMISSION AND TRANSFER ASSEMBLY
Support the transmission and transfer with a transmission jack.
5.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
6.REMOVE NO. 2 EXHAUST PIPE SUPPORT BRACKET
Remove the 2 bolts and No. 2 exhaust pipe support bracket from the No. 3 frame crossmember.
7.REMOVE AIR FUEL RATIO SENSOR
8.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Disconnect the No. 2 exhaust gas temperature sensor connector.
| *A | for 4WD |
| *B | for 2WD |
Disconnect the No. 3 exhaust gas temperature sensor connector and detach the clamp.
Disconnect the No. 6 exhaust pipe air hose and No. 7 exhaust pipe air hose from the front exhaust pipe.
Remove the 2 exhaust pipe supports.
Remove the 3 nuts and front exhaust pipe.
Remove the gasket.
9.REMOVE EXHAUST GAS TEMPERATURE SENSOR
10.REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR
11.REMOVE WIRING HARNESS CLAMP BRACKET
Remove the bolt and wiring harness clamp bracket.
12.REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR
13.REMOVE EXHAUST PIPE CLAMP SUB-ASSEMBLY
Remove the bolt, nut and exhaust pipe clamp.
14.REMOVE MONOLITHIC CONVERTER PROTECTOR
Remove the 4 bolts and 4 nuts.
| *1 | Upper Monolithic Converter Protector |
| *2 | Lower Monolithic Converter Protector |
Remove the upper monolithic converter protector and lower monolithic converter protector.
15.REMOVE CONVERTER PROTECTOR STAY
| *1 | No. 1 Converter Protector Stay |
| *2 | No. 2 Converter Protector Stay |
Remove the 2 No. 1 converter protector stays and 2 No. 2 converter protector stays.