Home › Engine / Hybrid System › 2TR-FBE INTAKE / EXHAUST › INTAKE MANIFOLD › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009591 2TR-FBE INTAKE / EXHAUST _0052351 INTAKE MANIFOLD A

2TR-FBE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STARTER ASSEMBLY

Hide 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 5.REMOVE FRONT UPPER FENDER APRON SEAL

a.

Remove the 5 clips and front upper fender apron seal.


Hide 7.REMOVE INTAKE MANIFOLD

a.
A261601

Detach the 3 wire harness clamps from the 2 wire harness clamp brackets.


b.
A261600

Remove the clamp.


c.

Detach the No. 1 fuel hose from the intake manifold.


d.
A261602

Detach the No. 2 water by-pass hose.


e.

Disconnect the No. 3 PCV hose and vacuum hose from the intake manifold.


f.
A262589

Remove the 5 bolts, 2 nuts and intake manifold.


g.

Remove the gasket from the intake manifold.


h.
A261603

Remove the 4 bolts then disconnect the 4 clamps and remove the No. 1 fuel pipe sub-assembly.


i.

Remove the 4 O-rings from No. 1 fuel pipe sub-assembly.


j.
A261604

Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.


k.

Remove the purge line hose from the intake manifold.


Hide 8.REMOVE STUD BOLT

NOTICE:

If a stud bolt is deformed or its threads are damaged, replace it.


a.

Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.