Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD › from 2012.04
RM1840EF _51 Engine / Hybrid System _009592 1GR-FE INTAKE / EXHAUST _0052357 EXHAUST MANIFOLD A

1GR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT FENDER SEAL RH

a.

Remove the 5 clips and fender seal RH.


Hide 2.REMOVE FRONT FENDER APRON SEAL UPPER RH

a.

Remove the 5 clips and fender apron seal upper RH.


Hide 3.REMOVE FRONT FENDER SEAL LH

a.

Remove the 5 clips and fender seal LH.


Hide 4.REMOVE FRONT FENDER APRON SEAL UPPER LH

a.

Remove the 5 clips and fender apron seal upper LH.


Hide 5.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 6.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

Hide 7.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

Hide 8.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts, 2 compression springs and 2 nuts.


b.

Disconnect the exhaust pipe support and remove the front exhaust pipe.


c.

Remove the 2 gaskets.


Hide 9.REMOVE NO. 2 MANIFOLD STAY

a.

Remove the 3 bolts and No. 2 manifold stay.


Hide 10.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.

Disconnect the air fuel ratio sensor connector.


b.
A167916

Remove the 6 nuts, exhaust manifold and gasket.


Hide 11.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

Hide 12.REMOVE MANIFOLD STAY

a.

Remove the 3 bolts and manifold stay.


Hide 13.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.

Disconnect the air fuel ratio sensor connector.


b.
A167915

Remove the 6 nuts, exhaust manifold and gasket.


Hide 14.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)