Home › Engine / Hybrid System › 2TR-FE COOLING › THERMOSTAT
RM1840EF _51 Engine / Hybrid System _009594 2TR-FE COOLING _0052368 THERMOSTAT A

2TR-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THERMOSTAT

a.
A301324
1.948,1.125 1.188,0.375 1.188,0.375 1.052,0.375 true 1.969,0.583 2.281,0.781 0.313,0.198 10 false *a 2.906,0.583 3.219,0.781 0.313,0.198 10 false *b 2.729,3.01 3.188,3.208 0.458,0.198 10 false : 10° 2.125,1.844 2.438,2.042 0.313,0.198 10 false *c 0.823,0.26 1.135,0.458 0.313,0.198 10 false *1
*1 Gasket
*a CORRECT
*b INCORRECT
*c Upward


Install a new gasket to the thermostat.

HINT:

When installing the thermostat to the gasket, be careful not to deform the gasket. Make sure that the thermostat is properly installed into the groove of the gasket as shown in the illustration.



b.

Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 10° of either side of the prescribed position.



Hide 2.INSTALL WATER INLET

a.

Install a new gasket and the water inlet with the 2 nuts and bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the power steering oil pressure switch connector.


Hide 3.CONNECT RADIATOR HOSE OUTLET

a.

Connect the radiator hose outlet to the water inlet.