1.INSTALL THERMOSTAT
| *1 | Gasket |
| *2 | Jiggle Valve |
| *a | CORRECT |
| *b | INCORRECT |
|
Upward |
Install a new gasket to the thermostat.
When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.
Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.
The jiggle valve may be set within 30° of either side of the prescribed position.
2.INSTALL WATER INLET
Install the wire harness clamp bracket to the water inlet with the bolt.
Install the water inlet with the 3 bolts.
Connect the wire harness clamp.
3.CONNECT RADIATOR HOSE OUTLET
Connect the radiator hose outlet to the water inlet.
4.INSTALL COMPRESSOR INLET ELBOW (w/ EGR Cooler)
5.INSTALL COMPRESSOR INLET ELBOW (for DPF)
6.INSTALL VENTILATION PIPE (w/ EGR Cooler)
7.INSTALL AIR CLEANER ASSEMBLY
8.INSTALL VENTILATION HOSE HEAT INSULATOR (w/o EGR Cooler)
9.INSTALL INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR (w/ EGR Cooler)
10.ADD ENGINE COOLANT
11.INSPECT FOR COOLANT LEAK
12.INSTALL NO. 1 ENGINE UNDER COVER