Home › Engine / Hybrid System › 2TR-FBE COOLING › THERMOSTAT
RM1840EF _51 Engine / Hybrid System _009596 2TR-FBE COOLING _0052379 THERMOSTAT A

2TR-FBE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THERMOSTAT

A301324
1.948,1.125 1.188,0.375 1.188,0.375 1.052,0.375 true 1.969,0.583 2.281,0.781 0.313,0.198 10 false *a 2.906,0.583 3.219,0.781 0.313,0.198 10 false *b 2.729,3.01 3.188,3.208 0.458,0.198 10 false : 10° 2.125,1.844 2.438,2.042 0.313,0.198 10 false *c 0.823,0.26 1.135,0.458 0.313,0.198 10 false *1
*1 Gasket
*a CORRECT
*b INCORRECT
*c Upward


a.

Install a new gasket to the thermostat.

HINT:

When installing the thermostat to the gasket, be careful not to deform the gasket. Make sure that the thermostat is properly installed into the groove of the gasket as shown in the illustration.



b.

Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 10° of either side of the prescribed position.



Hide 2.INSTALL WATER INLET

a.

Install a new gasket and the water inlet with the 2 nuts and bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the power steering pump connector.


Hide 3.CONNECT RADIATOR HOSE OUTLET

a.

Connect the radiator hose outlet to the water inlet.