Home › Engine / Hybrid System › 2TR-FBE COOLING › RADIATOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009596 2TR-FBE COOLING _0052380 RADIATOR A

2TR-FBE COOLING  RADIATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

w/ Airbag System:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE RADIATOR SIDE DEFLECTOR LH

a.

Using a clip remover, remove the 3 clips.


b.

Detach the claw and remove the deflector.


Hide 5.REMOVE RADIATOR SIDE DEFLECTOR RH

a.

Using a clip remover, remove the 3 clips.


b.

Detach the claw and remove the deflector.


Hide 6.REMOVE NO. 1 ENGINE UNDER COVER

Hide 8.DISCONNECT RADIATOR HOSE INLET

a.

Disconnect the radiator hose inlet from the radiator.


Hide 9.DISCONNECT RADIATOR HOSE OUTLET

a.

Disconnect the radiator hose outlet from the radiator.


Hide 11.REMOVE FAN SHROUD

A099963

a.

Disconnect the reservoir hose from the radiator.


b.

Loosen the 4 nuts holding the fluid coupling fan.


c.

Remove the fan and generator V belt (See page Engine / Hybrid System>2TR-FBE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).


d.

Remove the 2 bolts holding the fan shroud.


e.

Remove the 4 nuts holding the fluid coupling fan, and then remove the fan shroud together with the fluid coupling fan.

NOTICE:

Be careful not to damage the radiator core.



f.

Remove the fan pulley from the engine water pump.


Hide 12.DISCONNECT OIL COOLER INLET HOSE (for Automatic Transmission)

a.

Disconnect the oil cooler inlet hose from the radiator.


Hide 13.DISCONNECT OIL COOLER OUTLET HOSE (for Automatic Transmission)

a.

Disconnect the oil cooler outlet hose from the radiator.


Hide 14.REMOVE RADIATOR ASSEMBLY

a.
A110375

w/ Airbag System:

i.

Using a clip remover, detach the 4 clamps from the radiator as shown in the illustration.

HINT:

Tape the clip remover tip before use.




b.
A099640

Remove the 4 bolts and radiator.