1.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH
2.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
5.REMOVE V-BANK COVER
6.DISCONNECT RADIATOR HOSE OUTLET
Disconnect the radiator hose outlet from the water inlet housing.
7.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
Remove the 3 nuts, water inlet sub-assembly with thermostat and gasket.
If the thermostat was not installed, cooling efficiency would be harmed. Even if the engine tends to overheat, do not remove the thermostat.