Home › Engine / Hybrid System › 1GR-FE COOLING › RADIATOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009597 1GR-FE COOLING _0052385 RADIATOR A

1GR-FE COOLING  RADIATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH

Hide 4.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH

Hide 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 7.REMOVE RADIATOR SIDE DEFLECTOR LH

a.

Using a clip remover, remove the 2 clips.


b.

Detach the claw and remove the deflector.


Hide 8.REMOVE RADIATOR SIDE DEFLECTOR RH

a.

Using a clip remover, remove the 2 clips.


b.

Detach the claw and remove the deflector.


Hide 10.DISCONNECT RADIATOR HOSE INLET

a.

Disconnect the radiator hose inlet from the radiator.


Hide 11.DISCONNECT RADIATOR HOSE OUTLET

a.

Disconnect the radiator hose outlet from the radiator.


Hide 12.DISCONNECT OIL COOLER INLET HOSE

a.

Disconnect the oil cooler inlet hose from radiator tank lower.


Hide 13.DISCONNECT OIL COOLER OUTLET HOSE

a.

Disconnect the oil cooler outlet hose from radiator tank lower.


Hide 14.REMOVE FAN SHROUD

a.
A110406

Remove the 3 bolts and oil reservoir.


b.

Disconnect the reservoir hose from the radiator tank upper.


c.

Loosen the 4 nuts holding the fluid coupling fan.


d.

Remove the fan and generator V belt (See page Engine / Hybrid System>1GR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).


e.

Remove the 2 bolts holding the fan shroud.


f.

Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

NOTICE:

Be careful not to damage the radiator core.



g.

Remove the fan pulley from the water pump.


Hide 15.REMOVE RADIATOR ASSEMBLY

a.

Disconnect the 2 front airbag sensor connectors.


b.
A277660

Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

HINT:

Tape the clip remover tip before use.



c.
A112140

Remove the 4 bolts and radiator assembly.