Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › OIL PRESSURE SWITCH › from 2012.04
RM1840EF _51 Engine / Hybrid System _009600 1KD-FTV LUBRICATION _0052399 OIL PRESSURE SWITCH A

1KD-FTV LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the engine oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch.



b.

Using a 24 mm deep socket wrench, install the engine oil pressure switch to the oil cooler cover.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after the installation.



c.

Connect the engine oil pressure switch connector.