Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › ENGINE OIL COOLER › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009600 1KD-FTV LUBRICATION _0052400 ENGINE OIL COOLER A

1KD-FTV LUBRICATION  ENGINE OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 8.REMOVE OIL COOLER COVER SUB-ASSEMBLY

a.

Disconnect the oil pressure switch connector.


b.

Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.


c.
A038741

Remove the 13 bolts, oil cooler cover and gasket.


Hide 9.REMOVE OIL COOLER ASSEMBLY

a.
A224157

Loosen the 4 nuts.


b.

Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.


c.

Remove the 4 nuts, oil cooler and 2 gaskets.