Home › Engine / Hybrid System › 1KD-FTV FUEL › COMMON RAIL(w/o Glow Plug Controller) › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009579 1KD-FTV FUEL _0052230 COMMON RAIL(w/o Glow Plug Controller) A

1KD-FTV FUEL  COMMON RAIL(w/o Glow Plug Controller)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE DIESEL THROTTLE BODY ASSEMBLY (w/ EGR Cooler)

Hide 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 6.REMOVE NO. 2 ENGINE UNDER COVER

Hide 7.DRAIN ENGINE COOLANT (w/ EGR Cooler)

Hide 9.REMOVE MANIFOLD STAY WITH VACUUM SWITCHING VALVE (w/ EGR Cooler)

Hide 14.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 15.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET (w/ EGR Cooler)

Hide 17.REMOVE NO. 1 GAS FILTER WITH GAS FILTER BRACKET (w/ EGR Cooler)

Hide 18.REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/ EGR Cooler)

Hide 21.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER (w/ EGR Cooler)

Hide 23.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

a.

Disconnect the 3 fuel hoses.


b.
A301699
0.073,0.094 0.385,0.292 0.313,0.198 10 false *A 0.104,2.417 0.417,2.615 0.313,0.198 10 false *B 2.969,1.01 3.281,1.208 0.313,0.198 10 false *1 2.99,3 3.302,3.198 0.313,0.198 10 false *1
*A w/ EGR Cooler
*B w/o EGR Cooler
*1 Union Bolt


Remove the union bolt, 3 bolts, No. 2 nozzle leakage pipe and gasket.


Hide 26.REMOVE COMMON RAIL ASSEMBLY

NOTICE:

Do not remove the pressure discharge valve or fuel pressure sensor.


a.

Disconnect the 2 connectors.


b.
A231856

Remove the 2 bolts, common rail and No. 2 intake manifold insulator.