When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
3.DRAIN ENGINE OIL
4.REMOVE FUEL SUPPLY PUMP ASSEMBLY
w/ Glow Plug Controller: (See Page Engine / Hybrid System>1KD-FTV FUEL>FUEL SUPPLY PUMP(w/ Glow Plug Controller)>REMOVAL)
w/o Glow Plug Controller: (See Page Engine / Hybrid System>1KD-FTV FUEL>FUEL SUPPLY PUMP(w/o Glow Plug Controller)>REMOVAL)
5.REMOVE COMMON RAIL ASSEMBLY
w/ Glow Plug Controller: (See Page Engine / Hybrid System>1KD-FTV FUEL>COMMON RAIL(w/ Glow Plug Controller)>REMOVAL)
w/o Glow Plug Controller: (See Page Engine / Hybrid System>1KD-FTV FUEL>COMMON RAIL(w/o Glow Plug Controller)>REMOVAL)
6.REMOVE STARTER ASSEMBLY
for Denso Made: (See page Engine / Hybrid System>1KD-FTV STARTING>STARTER(for DENSO Made)>REMOVAL)
for Bocsh Made: (See page Engine / Hybrid System>1KD-FTV STARTING>STARTER(for BOSCH Made)>REMOVAL)
7.REMOVE OIL FILTER SUB-ASSEMBLY
8.REMOVE OIL COOLER COVER SUB-ASSEMBLY
Disconnect the oil pressure switch connector.
Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.
Remove the 13 bolts, oil cooler cover and gasket.
9.REMOVE OIL COOLER ASSEMBLY
Loosen the 4 nuts.
Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.
Remove the 4 nuts, oil cooler and 2 gaskets.