Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for DENSO Made) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009603 1KD-FTV STARTING _0052413 STARTER(for DENSO Made) A

1KD-FTV STARTING  STARTER(for DENSO Made)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

for Automatic Transmission:

Install the starter and ground cable with the 2 nuts and bolt.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


b.

for Manual Transmission:

Install the starter and ground cable with the nut and bolt.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


c.

Install the starter wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the starter connector.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 3.INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 4.INSTALL FRONT FENDER SEAL

a.

Install the seal with the 5 clips.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).