Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009608 CRUISE CONTROL _0052447 CRUISE CONTROL MAIN SWITCH A

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 6.REMOVE CRUISE CONTROL MAIN SWITCH

a.
E156725

Disconnect the connector.


b.

Remove the 2 screws.


c.
E156726

Remove the switch as shown in the illustration.