Home › Drivetrain › A340F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM1840EF _52 Drivetrain _009609 A340F AUTOMATIC TRANSMISSION / TRANSAXLE _0052455 PARK / NEUTRAL POSITION SWITCH A

A340F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C283100
0.969,1.521 1.719,1.521 true 1.938,1.281 1.938,0.427 1.938,0.427 1.792,0.427 true 1.594,0.344 1.906,0.5 0.313,0.156 10 false *1 0.771,1.438 1.083,1.594 0.313,0.156 10 false *2
*1 Lock Washer
*2 Lock Nut


a.

Install the park/neutral position switch to the manual valve shaft.


b.

Temporarily install the bolt.


c.

Install a new lock washer and the nut.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


d.
C236140
1.375,0.104 1.604,0.292 0.229,0.188 10 false N 1.771,0.427 2.01,0.635 0.24,0.208 10 false R 2.292,0.323 2.448,0.5 0.156,0.177 10 false P

Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


e.
C283078
1.958,1.573 0.667,1.26 true 1.948,0.948 1.771,0.24 1.771,0.24 1.927,0.24 true 1.99,0.135 2.302,0.292 0.313,0.156 10 false *1 0.469,1.156 0.781,1.313 0.313,0.156 10 false *2
*1 Neutral Basic Line
*2 Groove


Align the neutral basic line with the switch groove, and tighten the bolt.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


f.

Using a screwdriver, bend the tabs of the lock washer.


g.

Connect the switch connector.