Home › Drivetrain › A343E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION ASSEMBLY › from 2012.10
RM1840EF _52 Drivetrain _009610 A343E AUTOMATIC TRANSMISSION / TRANSAXLE _0052473 AUTOMATIC TRANSMISSION ASSEMBLY A

A343E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 4.REMOVE NO. 2 ENGINE UNDER COVER

Hide 7.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 9.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

Hide 10.DISCONNECT OIL COOLER TUBE

a.
C118031

Using a union nut wrench, disconnect the outlet oil cooler tube and inlet oil cooler tube.


b.
C282294

Remove the 3 bolts and 3 clamps.


Hide 11.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C282195

a.

Remove the nut and clip, and disconnect the transmission control cable.


Hide 12.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

C219908

a.

Support the automatic transmission assembly with a transmission jack.


Hide 13.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

a.
C238044

Detach the wire harness clamp from the No. 3 frame crossmember.


b.
G034517

Remove the 4 set bolts of the rear No. 1 engine mounting insulator.


c.

Remove the 4 nuts, 4 bolts and No. 3 frame crossmember.


Hide 14.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

C282295
0.833,0.135 0.979,0.135 0.979,0.135 1.302,0.375 true 0.656,0.042 0.969,0.198 0.313,0.156 10 false *1
*1 Ground Cable


a.

Remove the 4 bolts, ground cable and engine mounting insulator.


Hide 15.DISCONNECT WIRE HARNESS AND CONNECTOR

a.
C240769

Remove the 2 bolts and heat insulator.


b.
C282296

Tilt the transmission downward.

NOTICE:

Make sure the cooling fan does not contact the fan shroud.



c.

Disconnect the park/neutral position switch connector, transmission wire connector, ATF temperature sensor connector and 3 speed sensor connectors.

C238047


d.

Disconnect the 4 wire harness clamps.


Hide 16.REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT

a.

Remove the flywheel housing dust seal.


b.

Turn the crankshaft to gain access to each bolt.


c.
C118033

Hold the crankshaft pulley bolt with a wrench and remove the 6 torque converter setting bolts.


Hide 18.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

a.
C118035

Remove the 7 bolts and automatic transmission assembly.

NOTICE:

Do not use excess force to pry off the transmission assembly.



Hide 19.REMOVE TRANSMISSION CONTROL CABLE BRACKET

G024484

a.

Remove the 2 bolts and control cable bracket from the transmission.


Hide 20.REMOVE TORQUE CONVERTER ASSEMBLY

a.

Remove the torque converter from the automatic transmission assembly.