Home › Drivetrain › A343F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE
RM1840EF _52 Drivetrain _009611 A343F AUTOMATIC TRANSMISSION / TRANSAXLE _0052486 TRANSMISSION CONTROL CABLE A

A343F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Insert the transmission control cable from outside the vehicle and attach the 3 claws of the cable retainer.


b.

Install the 2 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


c.

Connect the transmission control cable to the shift lever retainer and install a new clip.


d.
C248293
2.802,0.188 2.656,0.188 2.656,0.188 2.448,0.615 true 2.854,0.094 3.104,0.281 0.25,0.188 10 false *1
*1 Ridge


Connect the control cable end to the shift lever.

NOTICE:

Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.



e.

Move the shift lever to N.


f.

Connect the transmission control cable support and ground cable with the 2 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


g.
C236140
1.365,0.094 1.521,0.271 0.156,0.177 10 N 1.75,0.417 1.906,0.594 0.156,0.177 10 R 2.271,0.313 2.427,0.49 0.156,0.177 10 P

Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


h.

Connect the transmission control cable to the transmission control cable bracket with a new clip, and then connect the cable end to the control shaft lever with the nut.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)