Home › Drivetrain › CLUTCH › CLUTCH ACCUMULATOR(for 1KD-FTV, 2KD-FTV)
RM1840EF _52 Drivetrain _009613 CLUTCH _0052513 CLUTCH ACCUMULATOR(for 1KD-FTV, 2KD-FTV) A

CLUTCH  CLUTCH ACCUMULATOR(for 1KD-FTV, 2KD-FTV)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CLUTCH ACCUMULATOR ASSEMBLY

a.

Install the clutch accumulator assembly with the 2 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.

Using a union nut wrench, connect the master cylinder to flexible hose tube and accumulator to flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2.BLEED AIR FROM CLUTCH PIPE LINE

Hide 3.CHECK FOR CLUTCH FLUID LEAKAGE

HINT:

Check for leaks in the clutch system.


Hide 4.CHECK FLUID LEVEL IN RESERVOIR