1.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
for R150/R151/R156: (See page Drivetrain>R150 / R151 / R156 MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION ASSEMBLY>REMOVAL)
for R150F/R151F/R156F: (See page Drivetrain>R150F /R151F / R156F MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION ASSEMBLY>REMOVAL)
2.REMOVE CLUTCH RELEASE FORK BOOT
3.REMOVE CLUTCH RELEASE BEARING ASSEMBLY
Remove the clutch release bearing assembly together with the clutch release fork sub-assembly from the clutch housing.
Remove the clutch release fork sub-assembly from the clutch release bearing assembly.
Remove the release bearing hub clip from the clutch release bearing assembly.
4.REMOVE RELEASE FORK SUPPORT
Remove the release fork support from the manual transmission unit.
5.REMOVE CLUTCH COVER ASSEMBLY
| *1 | Matchmark |
Place matchmarks on the clutch cover and flywheel.
Loosen each set bolt one turn at a time until spring tension is released.
Remove the 6 set bolts and pull off the clutch cover.
Do not drop the clutch disc.
6.REMOVE CLUTCH DISC ASSEMBLY
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.