Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.REMOVE FRONT SPEED SENSOR LH (w/ ABS)
Remove the bolt and speed sensor.
Disconnect the 2 clamps.
Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.
3.DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH
4.REMOVE FRONT DISC
5.REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD)
Using a screwdriver and hammer, remove the grease cap.
Do not damage the axle hub.
6.REMOVE FRONT AXLE SHAFT NUT LH (for 4WD)
Remove the cotter pin and lock cap.
Remove the axle shaft nut.
7.REMOVE FRONT AXLE HUB ASSEMBLY (for 4WD)
Remove the 4 bolts, dust cover and axle hub from the steering knuckle.
Remove the O-ring from the axle hub.
w/ ABS:
Remove the spacer and ABS rotor from the axle hub.
w/o ABS:
Remove the 2 spacers from the axle hub.
8.REMOVE FRONT AXLE HUB ASSEMBLY (for Pre-Runner)
Remove the 4 bolts, dust cover and axle hub from the steering knuckle.
Remove the O-ring from the axle hub.
9.REMOVE FRONT AXLE HUB INNER BEARING LH (for 4WD)
Fix the front axle hub in a soft vise.
Using SST, remove the bearing.
10.REMOVE FRONT AXLE HUB INNER BEARING LH (for Pre-Runner)
Using SST and a hammer, unstake the adjusting nut.
Using SST, remove the adjusting nut.
w/o ABS:
Remove the spacer from the axle hub.
w/ ABS:
Remove the sensor rotor from the axle hub.
Fix the front axle hub in a soft vise.
Using SST, remove the bearing.
11.REMOVE FRONT AXLE HUB OIL SEAL LH
Using a screwdriver, pry out the oil seal.