Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE(for 4WD and Pre-Runner)
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052557 STEERING KNUCKLE(for 4WD and Pre-Runner) A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT SPEED SENSOR LH (w/ ABS)

C113715

a.

Remove the bolt and speed sensor.


b.

Disconnect the 2 clamps.


c.

Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.


Hide 3.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

F042731

a.

Remove the bolt and disconnect the brake tube bracket from the steering knuckle.


b.
F050211

Remove the 2 bolts and disconnect the front disc brake cylinder from the steering knuckle.

NOTICE:

Use wire or an equivalent tool to keep the brake caliper from hanging down by the front flexible hose.



Hide 5.REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)

F042729

a.

Using a screwdriver and hammer, remove the grease cap.

NOTICE:

Do not damage the axle hub.



Hide 6.REMOVE FRONT AXLE SHAFT NUT LH (for 4WD)

F042732

a.

Remove the cotter pin and lock cap.


b.

Remove the shaft nut.


Hide 7.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

C099158

a.

Remove the nut and disconnect the stabilizer link from the steering knuckle.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



Hide 8.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 9.DISCONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH

F050870

a.

Remove the 2 bolts and disconnect the front suspension arm from the steering knuckle.


Hide 10.DISCONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH

F042736
1.917,0.771 2.563,0.26 2.563,0.26 2.781,0.26 true 2.865,0.156 3.188,0.354 0.323,0.198 10 false SST

a.

Remove the clip and nut.


b.

Using SST, disconnect the steering knuckle from the upper suspension arm.

SST
09628-62011  


Hide 11.REMOVE FRONT AXLE HUB DUST SEAL (for 4WD)

F042766

a.

Using a screwdriver and hammer, tap out the dust seal.


Hide 12.REMOVE KNUCKLE GREASE RETAINER CAP LH (for Pre-Runner)

F042756

a.

Using a screwdriver and hammer, remove the knuckle grease retainer cap.


Hide 13.REMOVE FRONT AXLE HUB ASSEMBLY

F042759

a.

Remove the 4 bolts, dust cover and axle hub from the steering knuckle.


b.

Remove the O-ring from the axle hub.