1.REMOVE NO. 1 ENGINE UNDER COVER
2.REMOVE NO. 2 ENGINE UNDER COVER
3.DRAIN DIFFERENTIAL OIL
4.REMOVE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY
Remove the bolt and disconnect the differential breather tube bracket.
Support the differential with a jack.
| *1 | Mounting Bolt |
| *2 | Mounting Nut |
Remove the No. 1 differential mounting nut.
Remove the 2 mounting bolts and 2 nuts.
Lower the jack.
Disconnect the connector.
Remove the 4 bolts.
Using a hammer, pry out the actuator from the differential tube.