Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.REMOVE REAR BRAKE
3.REMOVE REAR SPEED SENSOR LH (w/ ABS)
4.DISCONNECT PARKING BRAKE CABLE
Remove the 2 bolts and disconnect the parking brake cable.
5.REMOVE REAR AXLE SHAFT WITH BACKING PLATE
Remove the 4 nuts.
Pull out the axle shaft from the axle housing.
6.REMOVE O-RING
Remove the O-ring from the axle housing.
7.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, tap out the oil seal.
Be careful not to damage the axle housing hole.