Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT COIL SPRING LH
Using SST, compress the coil spring.
| *a | Correct |
| *b | Incorrect |
Attach the arm of SST to the diameter of the coil spring.
Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
Make sure that the claws of the hooks are securely attached.
Using SST, compress the coil spring.
If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
Do not compress the spring until the coil springs contact each other.
Do not use an impact wrench.
| *a | Recess |
Install the coil spring to the shock absorber. Fit the lower end of the coil spring into the recess of the spring lower seat.
2.INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
Install the cushion retainer to the shock absorber.
Install the suspension support to the shock absorber.
3.INSTALL FRONT SHOCK ABSORBER CUSHION
Install the cushion to the shock absorber.
4.INSTALL FRONT SHOCK ABSORBER CUSHION RETAINER
Install the cushion retainer to the shock absorber.
5.INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
| *1 | Suspension Support |
| *2 | Absorber Bush |
| *a | for LH |
| *b | Front |
| *c | for RH |
Align the suspension support and absorber bush as shown in the illustration.
Install a new lock nut.
Do not use an impact wrench. It will damage the shock absorber rod.
Release the coil spring while checking the position of the spring lower seat and suspension support.
6.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING
Install the shock absorber to the body so that the lower end of the coil spring faces the rear of the vehicle.
| *a | Fulcrum Length |
Using SST, install the 3 nuts to the upper side of the front shock absorber with coil spring.
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
for 4WD, for Pre-Runner (except TMT and TASA Made):
Temporarily install the bolt and nut as shown in the illustration.
Fix the nut in place and temporarily install the bolt.
for Pre-Runner (TMT and TASA Made):
Temporarily install the bolt and nut as shown in the illustration.
Fix the nut in place and temporarily install the bolt.
7.INSTALL FRONT STABILIZER BAR
8.INSTALL FRONT STABILIZER BRACKET
9.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
Connect the stabilizer link to the steering knuckle with the nut.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
10.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
11.INSTALL FRONT WHEEL
Install the front wheel.
12.STABILIZE SUSPENSION
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
13.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
Fix the nut in place and tighten the bolt.
Do not tighten the nut.
14.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT