Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR(for 4WD and Pre-Runner) › 2012.01–2012.04
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052594 FRONT SPEED SENSOR(for 4WD and Pre-Runner) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedure for the LH and RH sides.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT WHEEL

Hide 4.REMOVE FRONT SPEED SENSOR LH

a.

Disconnect the connector.

C280578
0.083,0.083 0.396,0.281 0.313,0.198 10 *A 3.99,0.094 4.302,0.292 0.313,0.198 10 *B
*A for LH *B for RH



b.

Detach the 2 clamps and the connector.


c.
C280577

Detach the 2 clamps.


d.
C280579

Detach the clamp.


e.

Remove the 2 bolts and 2 harness clamps.


f.

Detach the 2 clamps.

C280580
0.188,0.094 0.5,0.292 0.313,0.198 10 *A 3.969,0.125 4.281,0.323 0.313,0.198 10 *B
*A w/ VSC *B w/o VSC



g.

Remove the bolt and harness clamp.


h.

Remove the bolt and speed sensor.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.



Hide 5.REMOVE SKID CONTROL SENSOR CLAMP

a.

Remove the bolt and skid control sensor clamp from the knuckle.

C280583
0.167,0.125 0.479,0.323 0.313,0.198 10 *A 3.719,0.146 4.031,0.344 0.313,0.198 10 *B
*A for LH *B for RH