Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR(w/ VSC) › 2012.04–2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052597 YAW RATE AND ACCELERATION SENSOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND ACCELERATION SENSOR(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL YAW RATE SENSOR ASSEMBLY

a.

Connect the connector.

NOTICE:

Securely connect the connector.



b.

Install the yaw rate sensor to the crossmember.

NOTICE:
·

Do not use any parts which have been dropped or struck.

·

Make sure that there is no foreign matter or carpet between the bracket of the sensor and crossmember.

·

Do not do anything to deform the bracket of the sensor, such as kicking or stepping on it.




Hide 2.INSTALL SENSOR BRACKET

a.

Install the sensor bracket with the 2 bolts.

Torque:
14 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 3.INSTALL FLOOR CARPET COVER

a.

Insert the floor carpet cover into the sensor bracket.


b.

Insert the positioning boss of the floor carpet cover into the hole in the bracket of the sensor.


c.

Attach the 4 claws to install the floor carpet cover.


Hide 4.INSTALL FRONT SEAT ASSEMBLY RH

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 6.PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION