1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4.REMOVE STEERING PAD
for 3 Spoke:
for 4 Spoke:
5.REMOVE STEERING WHEEL ASSEMBLY
6.REMOVE STEERING COLUMN LOWER COVER
7.REMOVE STEERING COLUMN UPPER COVER
8.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
(See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL)
Do not replace the spiral cable with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with the battery connected and the ignition switch ON.
Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
Do not remove the steering angle sensor from the spiral cable.