Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.10–2012.01
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052600 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TS and CG Terminal Circuit  


DESCRIPTION

The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.

HINT:

Change to Test Mode (signal check) by connecting terminals TS and CG of the DLC3, and turning the ignition switch from off to ON.


WIRING DIAGRAM

C237134
5.477,1.762 5.838,1.918 0.361,0.156 10 A13 5.477,1.958 7.064,2.315 1.587,0.358 10 Skid Control ECU (Brake Actuator Assembly) 5.843,0.527 6.089,0.697 0.247,0.17 10 TS 0.914,0.513 1.161,0.683 0.247,0.17 10 TS 0.904,1.081 1.151,1.251 0.247,0.17 10 CG 0.491,1.801 0.845,1.985 0.354,0.184 10 G18 0.491,1.973 0.907,2.161 0.417,0.188 10 DLC3 5.534,0.414 5.788,0.619 0.253,0.205 10 15 1.283,0.4 1.543,0.625 0.26,0.226 10 12 1.296,0.982 1.557,1.208 0.26,0.226 10 4

CAUTION / NOTICE / HINT

NOTICE:
·

Before disconnecting the connector, make sure that there are no problems with the connection.

·

After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU)
a.

Turn the ignition switch off.


b.

Disconnect the skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G18-4 (CG) - Body ground Always Below 1 Ω
G18-12 (TS) - A13-15 (TS) Always Below 1 Ω
A13-15 (TS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR