This circuit is used to send control information from the skid control ECU (brake actuator assembly) to the ECM and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1203 | ECM Communication Circuit Malfunction | The engine, drivetrain and destination variations that are sent from the ECM do not match the ones of the skid control ECU. | ECM |
Check that the proper ECM and brake actuator assembly are installed.
| Result | Proceed to |
|---|---|
| Proper ECUs are installed | A |
| Proper ECUs are not installed | B |
A
B
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B