Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2011.10–2012.01
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052601 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1442  Invalid Data Received from Acceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor via the CAN communication system.

The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle condition.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1442 Invalid Data Received from Acceleration Sensor With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. Acceleration sensor (Yaw rate sensor assembly)
C1443 Invalid Data Received from Yaw Rate Sensor With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. Yaw rate sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the yaw rate sensor assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK DTC
a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.


d.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC is output A
DTC is not output B




A

B