Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(w/ VSC) › 2012.04–2012.10
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052607 BRAKE PEDAL(w/ VSC) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.

Install the support with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


b.

for Manual Transmission:

Attach the connector clamp and clamp to the brake pedal support sub-assembly.


c.

Install the bolt to the support.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 2.CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Apply a light coat of lithium soap base glycol grease to the clevis pin.


b.

Connect the push rod clevis to the brake pedal.


c.
C226774C01
1.031,2.417 1.031,1.646 1.031,1.646 0.802,1.646 true 1.958,0.802 1.427,0.26 1.427,0.26 1.177,0.26 true 2,1.896 2,2.75 2,2.75 2.375,2.75 true 0.948,0.156 1.219,0.365 0.271,0.208 10 false *1 0.583,1.563 0.844,1.75 0.26,0.188 10 false *3 2.458,2.656 2.74,2.885 0.281,0.229 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Install the clevis pin and a new clip.

NOTICE:

The clip must be installed as shown in the illustration.



d.

Install the return spring.


e.

Connect the stop light switch connector and brake pedal load sensing switch connector.


Hide 3.CHECK AND ADJUST BRAKE PEDAL HEIGHT

Hide 4.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).