Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(w/o VSC) › 2012.01–2012.04
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052608 BRAKE PEDAL(w/o VSC) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(w/o VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required disconnecting the cable from the battery terminal. Therefore, make sure to rear the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Disconnect the stop light switch connector.


b.
C226773C05
1.031,2.417 1.031,2.208 1.031,2.208 0.771,2.208 false 1.948,1.208 1.302,0.802 1.302,0.802 1.177,0.802 false 2.177,1.99 2.177,2.781 2.177,2.781 2.281,2.781 true 1,0.708 1.24,0.896 0.24,0.188 10 false *1 0.594,2.115 0.813,2.302 0.219,0.188 10 false *3 2.344,2.688 2.615,2.844 0.271,0.156 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Remove the return spring.


c.

Remove the clip and clevis pin.


d.

Disconnect the push rod clevis from the brake pedal.


Hide 5.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C226772

for 1KD-FTV and 2KD-FTV with Manual Transmission:

Detach the connector clamp and clamp from the brake pedal support sub-assembly.


b.
C228311
1.26,1.406 1.26,0.448 1.26,0.448 1.396,0.448 false 2.948,1.615 2.948,2.938 2.948,2.938 2.771,2.938 false 1.438,0.354 1.823,0.563 0.385,0.208 10 false *1 2.583,2.854 2.833,3.031 0.25,0.177 10 false *2
*1 Brake Pedal Support
*2 Instrument Panel Reinforcement


Remove the bolt from the support.


c.
C111300

Remove the 4 nuts and support.