1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
3.REMOVE BRAKE BOOSTER ASSEMBLY
Disconnect the vacuum warning switch connector and remove the vacuum warning switch from the booster.
Disconnect the vacuum hose.
Remove the check valve and grommet from the booster.
| *1 | Brake Pedal Return Spring |
| *2 | Clevis Pin |
| *3 | Clip |
Remove the return spring, clip and clevis pin.
Loosen the push rod clevis lock nut.
Remove the 4 nuts and push rod clevis.
Remove the booster and gasket.