Home › Brake › BRAKE SYSTEM (OTHER) › LOAD SENSING PROPORTIONING VALVE(w/ VSC) › 2011.10–2012.01
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052614 LOAD SENSING PROPORTIONING VALVE(w/ VSC) A

BRAKE SYSTEM (OTHER)  LOAD SENSING PROPORTIONING VALVE(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BLEND PROPORTIONING VALVE ASSEMBLY

a.

Install the 2 valves to the bracket with the 2 bolts and nut.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 2.INSTALL BLEND PROPORTIONING VALVE ASSEMBLY WITH BRACKET

a.
C190855
2.835,0.703 2.95,0.845 0.115,0.142 10 A 2.889,1.245 3.004,1.387 0.115,0.142 10 B 0.767,0.869 0.886,1.012 0.119,0.143 10 C

Install the blend proportioning valve assembly with bracket with the 3 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Tighten the 3 nuts uniformly in alphabetical order.



b.
C190857

Using a union nut wrench, connect the brake lines at the 6 points indicated by the arrows in the illustration.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Install 2 new clips.


Hide 4.BLEED CLUTCH LINE (for Manual Transmission)