1.INSTALL BLEND PROPORTIONING VALVE ASSEMBLY
Install the 2 valves to the bracket with the 2 bolts and nut.
2.INSTALL BLEND PROPORTIONING VALVE ASSEMBLY WITH BRACKET
Install the blend proportioning valve assembly with bracket with the 3 bolts.
Tighten the 3 nuts uniformly in alphabetical order.
Using a union nut wrench, connect the brake lines at the 6 points indicated by the arrows in the illustration.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Install 2 new clips.
3.BLEED BRAKE SYSTEM
4.BLEED CLUTCH LINE (for Manual Transmission)