1.INSTALL LOAD SENSING SPRING BUSH & BOOT KIT
Install the load sensing valve boot and load sensing spring boot to the spring.
Install the 2 dust seals, 2 collars and 2 No. 1 load sensing spring bushes and 2 No. 2 load sensing spring bushes to the load sensing spring assembly.
Apply lithium soap base glycol grease to all contact surfaces.
Make sure the valve side and shackle side of the spring are installed properly.
2.INSTALL NO. 1 AND NO. 2 SHACKLES
Install the adjusting nut and No. 2 shackle to the No. 1 shackle.
Tighten the lock nut.
Install the No. 1 shackle (with the No. 2 shackle) to the spring.
Install the 2 plate washers and spring washer with the bolt and nut.
3.INSTALL LOAD SENSING SPRING ASSEMBLY
Using pliers, install the spring to the valve body with the clip.
4.INSTALL LOAD SENSING VALVE BRACKET
Install the load sensing valve bracket to the valve with the nut and bolt.
5.INSTALL REAR FLEXIBLE HOSE BRACKET
Install the bracket and valve set plate to the valve 2 spring washer with the 2 nuts.
Install a new clip.
Using a union nut wench, connect the No. 6 brake tube to the rear brake flexible hose.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
6.INSTALL LOAD SENSING PROPORTIONING VALVE ASSEMBLY
Install the valve with the 3 bolts.
Using a union nut wrench, connect the 3 brake lines to the valve body.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
7.CONNECT NO. 2 LOAD SENSING SPRING SHACKLE
Connect the No. 2 shackle to the rear differential.
Install the bolt, collar and 2 load sensing valve bushes.
8.BLEED BRAKE SYSTEM (for TASA Made)
9.BLEED BRAKE SYSTEM (for TMT Made)
10.BLEED CLUTCH LINE (for Manual Transmission)
11.CHECK LOAD SENSING PROPORTIONING VALVE ASSEMBLY
12.ADJUST LOAD SENSING PROPORTIONING VALVE ASSEMBLY