Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 4WD and Pre-Runner)
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052625 FRONT BRAKE(for 4WD and Pre-Runner) G

BRAKE (FRONT)  FRONT BRAKE(for 4WD and Pre-Runner)  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring.

If necessary, replace the cylinder and piston.


Hide 2.CHECK PAD LINING THICKNESS

C111381

a.

Using a ruler, measure the pad lining thickness.

Standard thickness:

11.5 mm (0.453 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the pad.


Hide 3.CHECK DISC THICKNESS

C111382

a.

Using a micrometer, measure the disc thickness.

Standard Thickness:
Item Specified Condition
for 15 inch Front Disc Brake 25.0 mm (0.984 in.)
for 16 inch Front Disc Brake 28.0 mm (1.102 in.)


Minimum Thickness:
Item Specified Condition
for 15 inch Front Disc Brake 23.0 mm (0.906 in.)
for 16 inch Front Disc Brake 26.0 mm (1.024 in.)


If the disc thickness is less than the minimum, replace the disc.


Hide 4.CHECK DISC RUNOUT


b.

Install the disc with the 6 hub nuts.

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)


c.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


If the runout is more than the maximum, change the installation position of the disc so that the runout is the smallest possible. If the runout is more than the maximum even when the installation position is changed, grind the disc. If the disc thickness is less than the minimum, replace the disc.


d.

Remove the 6 nuts and disc.