Use the same procedure for the RH and LH sides.
The procedures listed below is for the LH side.
1.INSTALL FRONT NO. 1 WHEEL CYLINDER TUBE LH
Using a union nut wrench, install the wheel cylinder tube to the brake cylinder.
Do not bend or damage the wheel cylinder tube.
Do not allow any foreign matter such as dirt and dust to enter the wheel cylinder tube from the connecting points.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.INSTALL FRONT FLEXIBLE HOSE
Attach 2 new clips to the flexible hose.
Using a union nut wrench, connect the flexible hose to the brake tube and wheel cylinder tube while holding the flexible hose with a wrench.
Do not bend or damage the brake tube and wheel cylinder tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.BLEED BRAKE LINE (w/ VSC)
4.BLEED BRAKE LINE (for TASA Made)
5.BLEED BRAKE LINE (for TMT Made)
6.BLEED CLUTCH LINE (for Manual Transmission)
7.INSTALL FRONT WHEEL