Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE(for 2WD) › from 2012.10
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052628 FRONT BRAKE FLEXIBLE HOSE(for 2WD) A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT FLEXIBLE HOSE

a.

Install a new gasket and connect the front flexible hose to the disc brake cylinder assembly with a new union bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


b.

Install a new clip to the front flexible hose.

NOTICE:

Make sure the clip is completely pushed in.



c.

Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




d.

Install the front flexible hose to the absorber bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 4.INSTALL FRONT WHEEL

Torque:
152 N*m (1550 kgf*cm, 112 ft.*lbf)