1.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE
Attach a new clip to the flexible hose.
Connect the flexible hose to the 3-way.
Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.BLEED BRAKE LINE (for TASA Made)
3.BLEED BRAKE LINE (for TMT Made)
4.BLEED BRAKE LINE (for TDV Made)
5.BLEED BRAKE LINE (for TSAM Made)
6.BLEED CLUTCH LINE (for Manual Transmission)