Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE(w/ VSC) › 2011.10–2012.01
RM1840EF _54 Brake _009626 BRAKE (REAR) _0052631 REAR BRAKE FLEXIBLE HOSE(w/ VSC) A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 6 FLEXIBLE HOSE BRACKET

a.

Install the bracket with the 2 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 2.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE

a.

Connect the flexible hose to the connecting point with each brake tube, and then install 2 new clips.


b.

Using a union nut wrench, connect each brake tube to the flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the flexible hose to the connecting point with each brake tube, and then install 2 new clips.


d.

Using a union nut wrench, connect each brake tube to the flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 4.BLEED CLUTCH LINE (for Manual Transmission)