1.INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY
Install the parking brake switch to the lever with the screw.
Connect the parking brake switch connector.
Connect the cable to the lever with the 2 bolts and 2 nuts.
| *1 | Claw |
Return the claw to its original position.
Install the lever with the 2 bolts.
| *1 | Lock Nut |
| *2 | No. 1 Parking Brake Cable Adjusting Nut |
Install the No. 1 parking brake cable adjusting nut and lock nut.
2.ADJUST PARKING BRAKE
3.INSTALL PARKING BRAKE LEVER COVER
4.INSTALL CONSOLE BOX ASSEMBLY
w/ Console Box Lid:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Console Box Lid)>INSTALLATION)
w/o Console Box Lid:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION)
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).