Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for KD Series Engine) › from 2012.04
RM1840EF _55 Steering _009628 POWER ASSIST SYSTEMS _0052639 VANE PUMP(for KD Series Engine) A

POWER ASSIST SYSTEMS  VANE PUMP(for KD Series Engine)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL VANE PUMP ASSEMBLY

a.

Coat a new O-ring with MP grease and install it to the vane pump.


b.
G034432

Install the pump with the 2 nuts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C283129
1.781,1.302 2.01,1.833 2.01,1.833 2.219,1.833 true 2.271,1.729 2.583,1.885 0.313,0.156 10 false *1
*1 Union Nut Wrench


Using a union nut wrench, connect the tube to the vane pump.

Torque:
44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 3.CONNECT OIL RESERVOIR TO PUMP HOSE

a.
G034430

Connect the oil reservoir to pump hose with the clip.

HINT:
·

Connect the pump side of the hose so that the paint mark faces the front of the vehicle.

·

Make sure the claw of the clamp on the pump side faces the front of the vehicle.




b.

Attach the 6 clips to install the front fender apron seal LH.


Hide 4.ADD POWER STEERING FLUID

Hide 6.CHECK FOR POWER STEERING FLUID LEAK

Hide 7.INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE

a.

Install the crossmember brace with the 8 bolts.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 8.INSTALL NO. 1 ENGINE UNDER COVER

a.

Install the engine under cover with the 4 bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 9.INSTALL NO. 2 ENGINE UNDER COVER

a.

Install the engine under cover with the 4 bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)