Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1GR-FE) › 2012.04–2012.10
RM1840EF _55 Steering _009628 POWER ASSIST SYSTEMS _0052641 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL VANE PUMP ASSEMBLY

a.
C283127

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.
F051259

Install the wire harness clamp bracket with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect the oil pressure switch connector.

NOTICE:

Make sure that no oil adheres to the connector.



Hide 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C112619

Install a new gasket onto the pressure feed tube.


b.

Install the pressure feed tube with the union bolt.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 3.CONNECT OIL RESERVOIR TO PUMP HOSE

a.
F051257

Connect the hose with the clip.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 7.ADD POWER STEERING FLUID

Hide 9.CHECK FOR POWER STEERING FLUID LEAKAGE