Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1GR-FE) › from 2012.04
RM1840EF _55 Steering _009628 POWER ASSIST SYSTEMS _0052641 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

When installing, coat the parts indicated by the arrows with power steering fluid (see page Steering>POWER ASSIST SYSTEMS>VANE PUMP(for 1GR-FE)>COMPONENTS).



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 3.DRAIN POWER STEERING FLUID

Hide 4.DISCONNECT OIL RESERVOIR TO PUMP HOSE

a.
F051257

Disengage the clip and disconnect the hose.


Hide 5.DISCONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C112619

Remove the union bolt, then disconnect the pressure feed tube.


b.

Remove the gasket from the pressure feed tube.


Hide 6.REMOVE VANE PUMP ASSEMBLY

a.
F051259

Disconnect the oil pressure switch connector.


b.

Remove the bolt and wire harness clamp bracket.


c.
C283127

Remove the 2 bolts and vane pump.