1.INSTALL NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type)
Install the No. 2 radio bracket to the radio receiver with the 3 screws.
2.INSTALL NO. 2 RADIO BRACKET (for Radio Receiver Type)
Install the No. 2 radio bracket to the radio receiver with the 3 screws.
3.INSTALL NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type)
Install the No. 1 radio bracket to the radio receiver with the 3 screws.
4.INSTALL NO. 1 RADIO BRACKET (for Radio Receiver Type)
Install the No. 1 radio bracket to the radio receiver with the 3 screws.
5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)
Connect all the connectors.
Install the radio and display receiver assembly with bracket with the 4 screws.
6.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
Connect all the connectors.
Install the radio receiver assembly with bracket with the 4 screws.
7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).