Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › 2012.01–2012.04
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052647 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 4.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

a.
E225130

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio receiver assembly with bracket.


Hide 5.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

a.
E225131

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio receiver assembly with bracket.


Hide 6.REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)

a.
E225132

Remove the 3 screws and No. 1 radio bracket from the radio receiver.


Hide 7.REMOVE NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type)

a.
E225133

Remove the 3 screws and No. 1 radio bracket from the radio receiver.


Hide 8.REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)

a.
E225134

Remove the 3 screws and No. 2 radio bracket from the radio receiver.


Hide 9.REMOVE NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type)

a.
E225135

Remove the 3 screws and No. 2 radio bracket from the radio receiver.